|
Flying Flat Edge Polish Machine Features: 5- Micro-oscillating flat polishing heads 2- Opposing chamfering heads fixed at 45degrees, beveling and drip edge Touch-tech control panel for simple operation Led belt speed indicator for optimum performance Non-corrosive impact resistant exterior covering Set and polishing abrasives included Specifications are subject to verification Seller's comments:It's a low Hr machine, I believe less than 400 hrs. We also bought a complete set of polishing heads ,the good ones including 2 copper over a 1000.00. We also had to buy a voltage convertor to supply machine. It should have been part of original purchase , but it wasn't . We also bought a manual, the one we got was in French. 175.00. This machine is still on a skid and ready to go. We never even hooked it up. We had a large commercial job to do that had over 8000 linear ft of edge. We thought we had to polish front edge of tops and lower edge of apron. They changed this job to a mitered edge , so no polishing other than our joint. We would definitely certify that machine is in excellent working order. It still looks new. Nice machine. We could load it onto a truck no problem. Our shop is wired 600 volt 3 phase. They required the converter to reduce the voltage down to 400 volts 50 hz as the machine requires 230/400v. This unit new from Sasso costs 6000.00. This converter is part of the deal.
|
Air Compressors
Block Stone Profiling Machinery
Machines
