|
25 HP 1,200 RPMó3 PHASE MAIN MOTOR 48î MAX. BLADE DIAMETER & 4í FT. BLADE GUARD DIRECT BELT DRIVE WITH PILLOW BLOCK HOUSING 2ñ 14î X 14î X 1î THICK H-BEAMS FOR THE MAIN BEAM ASSEMBLY WITH RADIUS WHEELS AND 2î RODSñ 24í LONG MITSUBISHI PROGRAMMABLE CONTROLLER ON THE ELECTRICAL SYSTEM WITH A MAPLEíS KEYPAD FOR PROGRAMMING SEVERAL CUTS PER PIECE OF ROCK VARIABLE AND REPEATING WIDTH PROGRAMMING NYLON GUIDE SYSTEM ON THE RAISE AND LOWER 1 1/2î CASE HARDENED BALL BEARING LIFT SCREWS ON THE RAISE AND LOWER RISE AND FALL ON THE SADDLE 40 FT. OF RUNWAY MATERIALSñ 2î CFR RAILS AND 6 PITCH GEAR RACK AUTOMATIC GANTRY INDEXING AUTO RESTART BLOCK LENGTH AND HEIGHT DETECTION RACK AND PINON DRIVE ON THE CROSSTRAVEL AND GANTRY AUTOMATIC FORWARD, REVERSE, AND DOWN FEED GOVENOR CONTROLS PENDANT CONTROL PUSHBUTTON STATION FOR MANUAL CONTROLS SAFETY CUTOFFS ON THE WATER, AMPS, OVERTRAVEL, AND BLADE ROTATION EXTRAíS NOT INCLUDED IN THE PRICE ABOVE: $875.00ñ LASER LIGHT $88.00 -PER RUNNING FOOT FOR EXTRA 2î RAILS AND 6 PITCH GEAR RACK CUSTOMER RESPONSIBILITIES: *BLADE OR ANY TOOLING, OTHER THAN WHAT IS QUOTED, THAT IS NEEDED FOR THE MACHINE *FRESH WATER TO THE MACHINE *PUMP, PIPE, AND PLUMBING TO THE MACHINE *MAIN POWER ENTRANCE AND WIRE TO THE MACHINE *ANY COVER OR RETAINER WALLS AROUND THE MACHINE *DRAINAGE FROM THE MACHINE *REMOVAL OF ANY OBSTRUCTIONS OR DEBRIS FROM THE JOB SITE *CRANE OR OTHER MEANS FOR SETTING THE MACHINE *GRADING, BACKFILLING, SAND, BACKHOE, AND COMPACTION WORK *ANY EXTRAíS ON THE MACHINE, REQUESTED BY THE CUSTOMER, THAT IS NOT LISTED ON THE QUOTE *CONCRETE *CUSTOMER IS RESPONSIBLE FOR ANY AND ALL STATE CODE INSPECTIONS AND PERMITS THAT MAY BE REQUIRED FOR THE INSTALLATION OF NEW EQUIPMENT. SITE MUST BE READY WITH CONCRETE IN PLACE, POWER PULLED, AND WATER AT THE TIME OF INSTALLATION. FAILURE TO DO SO WILL RESULT IN ADDITIONAL INSTALLATION CHARGES DUE TO DOWN TIME OR ADDITIONAL TRIPS.
|
Air Compressors
Block Stone Profiling Machinery
Machines
